Toolpack:M3UA Use Case A:Configure MTP2 Link A
From TBwiki
(Difference between revisions)
(Created page with "=== '''''Applies to version(s): v2.9, v2.10, v3.0''''' === {{DISPLAYTITLE:Creating MTP2 Links}} Once you have created an MTP2 configuration, you must create the necessary MTP2...") |
|||
| Line 1: | Line 1: | ||
| − | === '''''Applies to version(s): | + | === '''''Applies to version(s): v3.0''''' === |
{{DISPLAYTITLE:Creating MTP2 Links}} | {{DISPLAYTITLE:Creating MTP2 Links}} | ||
Once you have created an MTP2 configuration, you must create the necessary MTP2 links. | Once you have created an MTP2 configuration, you must create the necessary MTP2 links. | ||
Latest revision as of 13:10, 2 August 2019
Applies to version(s): v3.0
Once you have created an MTP2 configuration, you must create the necessary MTP2 links. An MTP2 link is used to connect the MTP2 physical layer to a line service carrying SS7 signaling.
To create an MTP2 link:
1- Click MTP2 in the navigation panel.
2- Click Create New MTP2 Link in the MTP2 configuration window
3- Configure the new MTP2 link:
- Enter a name for the new link
- Select a connection mode
- Select a line service
- Assign timeslot(s) to the link
- Select a protocol type
- Select a DPC length
- Select a timeslot rate
- Select the type of Error Correction to use.
- Click Create
4- Verify that the "MTP2 link was successfully created" message appears
List of Parameters
Live States
