Toolpack:M3UA Use Case A:Configure MTP3 A

Allyntree (Talk | contribs)
(Created page with "=== '''''Applies to version(s): v3.0''' === {{DISPLAYTITLE:Creating an MTP3 Configuration}} Once you have set up the MTP2 layer of your SS7 system, you must create an MTP3 con...")
Newer edit →

---

Revision as of 13:14, 5 August 2019

Applies to version(s): v3.0

Once you have set up the MTP2 layer of your SS7 system, you must create an MTP3 configuration. MTP3 provides message routing between signaling points in an SS7 network.

To create an MTP3 configuration:

1- Select MTP3 from the navigation panel

2- Configure the new MTP3 service:

• Enter a name for the MTP3 configuration
• Make sure the Enabled and SSf Validation boxes are checked
• Select SP as the signaling point type
• Click Create

3- Verify that the "Mtp3Cfg was successfully created" message appears

List of Parameters

• Name
• Enabled
• Signaling Point Type

Timers

• T15 Timer
• T16 Timer
• T18 Timer
• T19 Timer
• T21 Timer
• T26 Timer

Advanced Parameters

• Ssf Validation
• Transfer Restricted required