Toolpack:M3UA Use Case A:Creating MTP3 Links A
From TBwiki
(Difference between revisions)
(Created page with "=== '''''Applies to version(s): v3.0''''' === {{DISPLAYTITLE:Creating MTP3 Links}} After you create an MTP3 linkset, you associate it with MTP3 links. This is done because the...") |
(→Applies to version(s): v3.0) |
||
| Line 35: | Line 35: | ||
| − | 6- Verify that the '''" | + | 6- Verify that the '''"Mtp3 link was successfully created"''' message appears and that the link appears in the Mtp3 Link list. |
| − | + | ||
| − | + | ||
| + | [[Image:Create_MTP3_Link_3_1.png]] | ||
==List of Parameters== | ==List of Parameters== | ||
Latest revision as of 10:44, 6 August 2019
Applies to version(s): v3.0
After you create an MTP3 linkset, you associate it with MTP3 links. This is done because the MTP3 links are used to bind with either an MTP2, M2PA, or M2Ua link. They are connected in a one-to-one fashion.
To create an MTP3 link:
1- Click MTP3 in the navigation panel.
2- Select an MTP3 network.
3- Select an MTP3 linkset
4- Click Create New Mtp3 Link in the MTP3 linkset configuration window
5- Configure the new MTP3 link:
- Enter a name for the link
- Under Type of link to bind, select MTP2
- Select an MTP2 link
- Click Create
6- Verify that the "Mtp3 link was successfully created" message appears and that the link appears in the Mtp3 Link list.
List of Parameters
- Depending on the type chosen:
- Link Test Slc
- Libk Test Characters
