Toolpack:M3UA Use Case B:Configure NAP A

Allyntree (Talk | contribs)
(Created page with "=== '''''Applies to version(s): v3.0''''' === {{DISPLAYTITLE:Creating a NAP (ISUP)}} A Network Access Point (NAP) represents the entry point to another network or destination ...")
Newer edit →

---

Revision as of 10:24, 23 August 2019

Applies to version(s): v3.0

A Network Access Point (NAP) represents the entry point to another network or destination peer.

After you have created an ISUP CIC group, you must create a network access point.

To create a network access point (NAP):

1- Click NAPs in the navigation panel

2- Click Create New NAP

3- Configure the new NAP:

• Enter a name for the NAP
• Select a user-created profile, if not, select default
• Click Create

4- Verify that the NAP was successfully created message appears

5- Associate an ISUP interface with the NAP:

• Select an interface (the newly-created ISUP CIC group)
• Click the "<<" button to add the interface to the list

The following information is displayed:

• Select a value for Channel Usage, to avoid call collision
• Click Save

6- Verify that the "NAP was successfully updated" message appears

List of Parameters

• Name
• Default Profile
• Channel Usage

Advanced Parameters-Call rate limiting

• Maximum calls per second
• Maximum call burst
• Maximum simultaneous incoming calls
• Maximum simultaneous outgoing calls
• Maximum simultaneous total calls
• Processing delay low threshold
• Processing delay high threshold