Toolpack:M3UA Use Case B:Configure NAP A
From TBwiki
(Difference between revisions)
(→Applies to version(s): v3.0) |
(→Applies to version(s): v3.0) |
||
| Line 32: | Line 32: | ||
| − | 5- Associate | + | 5- Associate the recently created CIC Group with the NAP: |
| − | *Select | + | *Select the range of available CIC groups. |
| − | *Click the '''"<<"''' button to add the | + | *Click the '''"<<"''' button to add the CIC group to the list |
| − | [[Image: | + | Before: |
| + | [[Image:CreateIsupNap_4_1.png]] | ||
| − | + | After: | |
| + | [[Image:CreateIsupNap_5_1.png]] | ||
| − | |||
| − | |||
| − | |||
| − | |||
Revision as of 10:32, 23 August 2019
Applies to version(s): v3.0
A Network Access Point (NAP) represents the entry point to another network or destination peer.
After you have created an ISUP CIC group, you must create a network access point.
To create a network access point (NAP):
1- Click NAPs in the navigation panel
2- Click Create New NAP
3- Configure the new NAP:
- Enter a name for the NAP
- Select a user-created profile, if not, select default
- Click Create
4- Verify that the NAP was successfully created message appears
5- Associate the recently created CIC Group with the NAP:
- Select the range of available CIC groups.
- Click the "<<" button to add the CIC group to the list
Before:
After:
6- Verify that the "NAP was successfully updated" message appears
List of Parameters
Advanced Parameters-Call rate limiting
