Ethernet Bonding
From TBwiki
(Difference between revisions)
(→Configuration) |
(→Configuration) |
||
| Line 5: | Line 5: | ||
==Configuration== | ==Configuration== | ||
To learn how to configure ethernet bonding, refer to: | To learn how to configure ethernet bonding, refer to: | ||
| − | * To learn how to configure ethernet bonding for an FreeSBC or ProSBC, refer to [[ | + | * To learn how to configure ethernet bonding for an FreeSBC or ProSBC, refer to [[TSBC-SW:WebPortal:Initial_Configuration|FreeSBC/ProSBC Initial Configuration]] |
* To learn how to configure ethernet bonding for a TMG7800, refer to [[https://docs.telcobridges.com/tbwiki/TMG7800-CTRL-SW:WebPortal:Initial_Configuration|TMG7800 Initial Configuration]] | * To learn how to configure ethernet bonding for a TMG7800, refer to [[https://docs.telcobridges.com/tbwiki/TMG7800-CTRL-SW:WebPortal:Initial_Configuration|TMG7800 Initial Configuration]] | ||
Revision as of 13:40, 26 March 2020
Ethernet Bonding enables SBC and Tmedia units to use the two Ethernet ports as a bonding pair. When the active port becomes unusable (cable disconnected, limited connectivity), the other port is used to transport Ethernet traffic.
Note: Ethernet bonding can be configured on an SBC and a 7800-ctrl, but only when running these units are configured in a Bare Metal mode.
Configuration
To learn how to configure ethernet bonding, refer to:
- To learn how to configure ethernet bonding for an FreeSBC or ProSBC, refer to FreeSBC/ProSBC Initial Configuration
- To learn how to configure ethernet bonding for a TMG7800, refer to [Initial Configuration]
Display Status
To learn about how to view the status, refer to:
