Ethernet Bonding
From TBwiki
(Difference between revisions)
(→Display Status) |
|||
| Line 10: | Line 10: | ||
==Display Status== | ==Display Status== | ||
To learn about how to view the status, refer to: | To learn about how to view the status, refer to: | ||
| − | *[[Toolpack: | + | *[[Toolpack:EthernetBondingStatus_A|Ethernet Bonding Status]] |
Revision as of 14:07, 30 March 2020
Ethernet Bonding enables SBC and Tmedia units to use the two Ethernet ports as a bonding pair. When the active port becomes unusable (cable disconnected, limited connectivity), the other port is used to transport Ethernet traffic.
Note: Ethernet bonding can be configured on an SBC and a 7800-ctrl, but only when running these units in a Bare Metal configuration.
Configuration
To learn how to configure ethernet bonding, refer to:
- To learn how to configure ethernet bonding for an FreeSBC or ProSBC, refer to FreeSBC/ProSBC Initial Configuration
- To learn how to configure ethernet bonding for a TMG7800, refer to TMG7800 Initial Configuration
Display Status
To learn about how to view the status, refer to:
