Toolpack:Reset HostRole A
From TBwiki
(Difference between revisions)
m |
|||
| Line 1: | Line 1: | ||
| − | === '''''Applies to version(s) v2.8, v2.9, v2.10, v3.0, v3.1''''' === | + | === '''''Applies to version(s) v2.8, v2.9, v2.10, v3.0, v3.1, v3.2''''' === |
{{DISPLAYTITLE:Resetting the Host Role}} | {{DISPLAYTITLE:Resetting the Host Role}} | ||
Revision as of 10:38, 21 July 2020
Applies to version(s) v2.8, v2.9, v2.10, v3.0, v3.1, v3.2
If you need to change internal IP addresses, you must reset the host role settings of the unit.
To reset the host role, do the following:
1- Click Hosts in the navigation panel.
2- Select the serial number of the unit.
3- Click the Status tab.
4- Select Reset Host Role
- Click Apply Action
5- The Web Portal setup wizard is displayed. (You may need to refresh your web page to see this)
