Toolpack:Modifying ISUP Userpart for SPIROU B
From TBwiki
(Difference between revisions)
m |
m |
||
| Line 1: | Line 1: | ||
| − | === '''''Applies to version(s): | + | === '''''Applies to version(s): 2.8, 2.9, 2.10, 3.0, 3.2''''' === |
{{DISPLAYTITLE:Modifying ISUP Userpart for SPIROU}} | {{DISPLAYTITLE:Modifying ISUP Userpart for SPIROU}} | ||
| − | This article assumes that ''SS7 ISUP is configured | + | This article assumes that ''SS7 ISUP is configured''. |
1- Select '''ISUP''' from the navigation panel | 1- Select '''ISUP''' from the navigation panel | ||
Revision as of 12:49, 21 August 2020
Applies to version(s): 2.8, 2.9, 2.10, 3.0, 3.2
This article assumes that SS7 ISUP is configured.
1- Select ISUP from the navigation panel
2- Select the ISUP stack you wishto configure.
3- In the Editing Userparts section, select the ISUP userpart you to configure.
4- Select SPIROU in the Protocol Variant drop-down menu.
5- A new checkbox Strict SPIROU validation appears once SPIROU Protocol Variant is selected.
- Select this checkbox to make sure your configuraton is compliant with SPIROU.
6- Click Timers to expand the Timers section
- Set T6 Timer to a value between 60000 and 120000 ms (between 60 and 120 seconds)
7- Click Advanced Parameters to expand the Advanced Parameters section
- Uncheck the Allow group messages option
- Click Save
8- Verify that the "IsupUserpart was successfully updated" message is displayed
List of Parameters
- Name
- Protocol Variant
- MTP3 Sub Service field
- Default Nature of Address When Unspecified
- Default Numbering Plan When Unspecified
