Toolpack:Configure TMG7800 Ethernet Bonding A
From TBwiki
(Difference between revisions)
(→Applies to version(s): v3.2) |
(→Applies to version(s): v3.2) |
||
| Line 13: | Line 13: | ||
3. Click the Status tab.<br> | 3. Click the Status tab.<br> | ||
| + | *Select '''Change Network Devices Role'''.<br> | ||
[[Image:ConfigureEthernetBonding_2.png]] <br> | [[Image:ConfigureEthernetBonding_2.png]] <br> | ||
Revision as of 13:58, 14 September 2020
Applies to version(s): v3.2
Ethernet Bonding enables two Ethernet ports to be used as bonding pair. This ensures for a reliability of service. If the active port becomes unusable the other port in the bonding pair is used to transport traffic.
To configure Ethernet Bonding:
1. Select Hosts from the navigation panel.
2. Select a Host from the Hosts Configuration list.
3. Click the Status tab.
- Select Change Network Devices Role.
4. Select Reset Host Role.
5. A Role Configuration window is displayed.
- Set LAN/WAN role to the 2 Ethernet interfaces you want to bond.
- Click add bonding
- The bonding pair is displayed below.
- Give a name to the bond.
- For each LAN/WAN select the associated interface for the bond
- Click continue
To verify the Ethernet Bond:
1. Select IP Interfaces from the navigation panel.
2.The bond0 ports are shown.
- Click the Status tab.
3. Click the Ethernet Bondings Tab.
- Select a Host to view more details.
- An Ethernet bonding status window is displayed
List of Parameters
Advanced Parameters
