FreeSBC:Cloud:AWS Additional Interface A

Revision as of 05:18, 18 September 2020

This page is intended to give assistance to people to add an additional interface to an existing AWS ProSBC Instance.

Adding a new interface to AWS

• After logging in your Amazon account, click on “EC2” in the main AWS console:

• Select the instance you want to add additional network interface and note the Availability Zone (AZ) and security group name.

• Go to Network&Security Select Network Interfaces and Click to Create Network Interface Button

• Give a name, select the subnet and security groups. The subnet must be in the same AZ and the security group can be the same with the existing PROSBC security group.

Adding a new interface to PROSBC INstance

• Stop the instance
• Select the Instance Actions -> Networking -> Attach Network Device

• Select the newly created interface from the drop-down menu and Click to Attach Button

• When you run the instance it will take you to the initial configuration steps again to configure the new interface

Web Portal Initial Configuration

Click on the following link to pursue installation from the web portal: TSBC-SW:WebPortal:Initial Configuration

The Following table provides maximum supported network interfaces by instance type:

*