M2UA
From TBwiki
(Difference between revisions)
Cboulanger (Talk | contribs) |
Cboulanger (Talk | contribs) |
||
| Line 12: | Line 12: | ||
== References == | == References == | ||
| − | |||
[[category:Glossary]] | [[category:Glossary]] | ||
[[category:Needs revising]] | [[category:Needs revising]] | ||
Revision as of 10:34, 22 October 2009
The M2UA (Message Transfer Part 2 User Adaptation Layer) is use to interface MTP2 of the SG to the MTP3 of a MGC. M2UA can also be seen as way to extend a MTP2 link. An M2UA link is always bind to an MTP2 link.
Here is a diagram of a setup using M2UA:
As you can see the M2UA layer can be interface with either NIF or MTP3. Therefore M2UA has 2 modes of operation. Toolpack can configure M2UA in both modes.
