Toolpack v2.3:Status Menus:TDM Lines
(Created page with 'General and detailed status information about the TDM lines, also referred to as Adapters is accessible from the TDM Lines tab of the Global Status view. == General view == The…') |
(→General view) |
||
| Line 7: | Line 7: | ||
| − | [[Image: | + | [[Image:Web_Portal_v2.3_Tdm_Lines.png|700px]] |
| − | + | ||
== Detailed view == | == Detailed view == | ||
Revision as of 10:38, 25 October 2009
General and detailed status information about the TDM lines, also referred to as Adapters is accessible from the TDM Lines tab of the Global Status view.
Contents |
General view
The TDM Lines general view, shown below, provides information about the physical line interfaces of a TDM module and the line services that they carry. From this view you can know the status of line interfaces and line services by seeing if they are up, down, defective, or in an alarmed state. Selecting an active link will display the detailed view for line interfaces and line services.
Detailed view
The TDM Lines detailed view groups status information into two screens, as follows:
- Line Interface Listing
- Line Service Detailed Status
Line Interface Listing
The Line Interface listing, shown below, displays an expanded listing of each line interface and its associated line service and status. Selecting a line service from this screen displays its detailed information.
Line Service Detailed Status
The Line Service Detailed Status screen, shown below, enables you to view the state of a line service and to set a loopback on the line service for testing purposes. Configuring a local loopback allows the line service to be verified without having to access an outside line.
To activate a local loopback
1. Set Loopback to LOCAL
2. Click Apply States
