Toolpack v2.3:Create an SCCP Userpart
(Created page with 'The Userpart is the container for the multiple SCCP interfaces. One Userpart is required for each protocol variant. multiple SCCP userpart can be instantiated within a single SC…') |
(→To Create an SCCP User Part) |
||
| Line 27: | Line 27: | ||
[[Image:Web_Portal_v2.3_SCCP_User_Part_Created.png|700px]] | [[Image:Web_Portal_v2.3_SCCP_User_Part_Created.png|700px]] | ||
| + | |||
| + | |||
| + | '''4. Set an SCCP Backup Point Code''' | ||
| + | *Select a point code from the menu | ||
| + | |||
| + | [[Image:Web_Portal_v2.3_SCCP_Backup_Point_Code.png|700px]] | ||
| + | |||
| + | *Add the selection using the '<<' arrow button | ||
| + | |||
| + | [[Image:Web_Portal_v2.3_SCCP_Backup_Point_Code_2.png|700px]] | ||
Revision as of 09:28, 8 November 2009
The Userpart is the container for the multiple SCCP interfaces. One Userpart is required for each protocol variant.
multiple SCCP userpart can be instantiated within a single SCCP protocol layer. This allows a user application to interface with multiple SS7 SCCP protocol variants at the same time. Only one SCCP userpart is required for a specific variant as it can be assigned to multiple SCCP networks.
A Userpart can easily be seen as a protocol variant that a host application wants to use on the SS7 network.
To Create an SCCP User Part
1. Click 'Create New SCCP User Part' to access the SCCP configuration window.
2. Enter a name for the SCCP user part.
- Select a protocol variant
- Click 'Create' to save the changes
3. Verify that the 'SCCP Userpart was successfully created' message appears.
4. Set an SCCP Backup Point Code
- Select a point code from the menu
- Add the selection using the '<<' arrow button
