Toolpack v2.3:Creating a NAP
(→To create a Network Access Point) |
m (Added explanantion of channel usage) |
||
| Line 57: | Line 57: | ||
'''9. Click 'Save' to store the settings.''' | '''9. Click 'Save' to store the settings.''' | ||
| + | |||
| + | |||
| + | For ISDN and SS7 NAPs, you also need to select channel usage (trunk group hunting method) | ||
| + | * Lowest/Highest timeslot: Start from lowest (highest) timeslot of every trunk and will reuse them | ||
| + | * Lowest/Highest CIC (SS7 only): Start from lowest (highest) CIC and will reuse them | ||
| + | * Round-robin: Start from lowest timeslot of every trunk and increment for each call | ||
| + | |||
| + | For SIP NAPs, you need to specify IP address of destination and other parameters | ||
Revision as of 07:33, 18 December 2009
The Network Access Point (NAP) allows for SAPs, ISDN stacks, and SS7 ISUP interfaces to be associated as a combined resource for one type of access. A NAP is used to represent a collection of voice endpoints, for example: a group of SS7 CICs, ISDN controlled timeslots, SIP outgoing proxy to a specific provider, and more. (SAPs are, later in the configuration process, used to define how calls are routed out of the Tmedia system.)
In the example that follows, a Network Access Point is set for an ISP and another NAP is set for circuit-switched voice.
To create a Network Access Point
1. Select 'NAP' from the navigation panel.
2. Click 'Create New NAP' to access the NAP configuration window.
3. Provide a name for the NAP.
- Click 'Create' to initialize the NAP.
4. Verify that the 'NAP was successfully created' message appears.
5. Use the << button to associate either a SAP, ISDN stack, or ISUP interface with the NAP.
6. Click 'Save' to store the changes.
7. Verify that the newly created NAP is listed in the NAP list.
- Click 'Create New NAP' to add an additional NAP to the NAP list
8. Enter name for the new NAP.
- Use the << button to associate either a SAP, ISDN stack, or ISUP interface with the NAP. In this example, an ISDN signaling stack is selected for a circuit-switched service.
9. Click 'Save' to store the settings.
For ISDN and SS7 NAPs, you also need to select channel usage (trunk group hunting method)
- Lowest/Highest timeslot: Start from lowest (highest) timeslot of every trunk and will reuse them
- Lowest/Highest CIC (SS7 only): Start from lowest (highest) CIC and will reuse them
- Round-robin: Start from lowest timeslot of every trunk and increment for each call
For SIP NAPs, you need to specify IP address of destination and other parameters
10. Verify that the newly created NAPs appear in the NAP listing.
Verifying Status
To verify the status of the NAP configuration, either select Status from the Navigation panel or select the Status tab in the Information panel.
