Toolpack v2.4:Create an MTP3 Configuration
From TBwiki
(Difference between revisions)
(→To create an MTP3 configuration:) |
(→To create an MTP3 configuration:) |
||
| Line 10: | Line 10: | ||
*Enter a name for the MTP3 configuration | *Enter a name for the MTP3 configuration | ||
| + | *Set Enabled status: | ||
*Select '''SP''' as the signalling point type | *Select '''SP''' as the signalling point type | ||
| + | *Set SSf validation: | ||
| + | *Set restart procedure: | ||
| + | *Set Transfer Restricted Required: | ||
*Click "Save" to finalize the configuration | *Click "Save" to finalize the configuration | ||
Revision as of 12:45, 8 January 2010
MTP3 provides message routing between signaling points in an SS7 network.
To create an MTP3 configuration:
1. Select "MTP3" from the navigation panel:
2. Configure the new MTP3 service:
- Enter a name for the MTP3 configuration
- Set Enabled status:
- Select SP as the signalling point type
- Set SSf validation:
- Set restart procedure:
- Set Transfer Restricted Required:
- Click "Save" to finalize the configuration
3. Verify that the "Mtp3Cfg was successfully updated" message appears:
