Toolpack:Creating an MTP3 Configuration A
From TBwiki
(Difference between revisions)
| Line 11: | Line 11: | ||
* Enter a '''name''' for the MTP3 configuration | * Enter a '''name''' for the MTP3 configuration | ||
| − | * | + | * Make sure the '''Enabled''' and '''SSf Validation''' boxes are checked |
* Select '''SP''' as the '''signaling point type''' | * Select '''SP''' as the '''signaling point type''' | ||
| − | |||
* Select a '''restart procedure''' | * Select a '''restart procedure''' | ||
* Set a value for '''Transfer Restricted Required''' | * Set a value for '''Transfer Restricted Required''' | ||
Revision as of 15:57, 30 June 2010
Now that you have created originating and destination point codes (OPC and DPC), you must create an MTP3 configuration for your system. MTP3 provides message routing between signaling points in an SS7 network.
To create an MTP3 configuration:
1- Select MTP3 from the navigation panel
2- Configure the new MTP3 service:
- Enter a name for the MTP3 configuration
- Make sure the Enabled and SSf Validation boxes are checked
- Select SP as the signaling point type
- Select a restart procedure
- Set a value for Transfer Restricted Required
- Click Create
3- Verify that the Mtp3Cfg was successfully updated message appears
