Toolpack:Creating an SCCP Route A
From TBwiki
(Difference between revisions)
| Line 1: | Line 1: | ||
| + | Now that you have created an [[SCCP]] LSAP, you must create a new [[Toolpack:Create_an_SCCP_Route|SCCP route]] for your system. | ||
| + | This step in the Web Portal configuration exists to create a route to a specific destination point code (DPC). | ||
| + | |||
To Create an SCCP Route: | To Create an SCCP Route: | ||
| + | |||
1- Click '''Create new Sccp Route''' in the SCCP LSAP configuration window | 1- Click '''Create new Sccp Route''' in the SCCP LSAP configuration window | ||
| Line 16: | Line 20: | ||
[[Image:Toolpack_v2.5_Creating_SCCP_Route.png]] | [[Image:Toolpack_v2.5_Creating_SCCP_Route.png]] | ||
| − | 3- Verify that the '''SccpRoute was successfully created''' message appears | + | 3- Verify that the '''"SccpRoute was successfully created"''' message appears |
[[Image:Toolpack_v2.5_SCCP_Route_Created.png]] | [[Image:Toolpack_v2.5_SCCP_Route_Created.png]] | ||
Revision as of 10:59, 15 July 2010
Now that you have created an SCCP LSAP, you must create a new SCCP route for your system. This step in the Web Portal configuration exists to create a route to a specific destination point code (DPC).
To Create an SCCP Route:
1- Click Create new Sccp Route in the SCCP LSAP configuration window
2- Configure the new SCCP Route:
- Choose a name for the new route
- Select a protocol variant
- Select a replicant mode
- Select an SLS mask (this is only for ANSI and TELCORDIA protocol variants)
- Select a destination point code (DPC)
- Click Create
3- Verify that the "SccpRoute was successfully created" message appears
