Toolpack:Creating an M3UA Configuration (ASP) A
From TBwiki
(Difference between revisions)
(Created page with 'To create an M3UA configuration on an ASP: 1- Click '''M3UA''' in the navigation panel Image:Toolpack_v2.5_Navigation_Panel_M3UA.png 2- Configure the M3UA service for SGP:…') |
|||
| Line 1: | Line 1: | ||
| + | To set up your M3UA system on an application server process (ASP), you must first create a new M3UA configuration. | ||
| + | In this configuration the SS7 MTP2 layer is replaced entirely by the SIGTRAN M3UA layer, and the MTP3 layer is extended over the IP network. | ||
| + | |||
To create an M3UA configuration on an ASP: | To create an M3UA configuration on an ASP: | ||
| + | |||
1- Click '''M3UA''' in the navigation panel | 1- Click '''M3UA''' in the navigation panel | ||
| Line 5: | Line 9: | ||
[[Image:Toolpack_v2.5_Navigation_Panel_M3UA.png]] | [[Image:Toolpack_v2.5_Navigation_Panel_M3UA.png]] | ||
| − | 2- Configure the M3UA service for | + | 2- Configure the M3UA service for ASP: |
* Enter a '''name''' for the configuration | * Enter a '''name''' for the configuration | ||
| − | * Select | + | * Select '''Application Server Process (ASP)''' as the node type |
* Click '''Create''' | * Click '''Create''' | ||
[[Image:Toolpack_v2.5_Creating_ASP_M3UA_Configuration.png]] | [[Image:Toolpack_v2.5_Creating_ASP_M3UA_Configuration.png]] | ||
| − | 3- Verify that the '''M3ua Cfg was successfully created''' message appears | + | 3- Verify that the '''"M3ua Cfg was successfully created"''' message appears |
[[Image:Toolpack_v2.5_M3UA_IPSP_Configuration_Created.png]] | [[Image:Toolpack_v2.5_M3UA_IPSP_Configuration_Created.png]] | ||
Revision as of 12:37, 15 July 2010
To set up your M3UA system on an application server process (ASP), you must first create a new M3UA configuration. In this configuration the SS7 MTP2 layer is replaced entirely by the SIGTRAN M3UA layer, and the MTP3 layer is extended over the IP network.
To create an M3UA configuration on an ASP:
1- Click M3UA in the navigation panel
2- Configure the M3UA service for ASP:
- Enter a name for the configuration
- Select Application Server Process (ASP) as the node type
- Click Create
3- Verify that the "M3ua Cfg was successfully created" message appears
