Toolpack:Creating an MTP3 Network A
From TBwiki
(Difference between revisions)
(Created page with 'Now that you have created your system's MTP3 configuration, you must create a new MTP3 network. An MTP3 network is created to define its point codes, link sets and routes. This c…') |
|||
| Line 26: | Line 26: | ||
[[Image:Toolpack_v2.5_MTP3_Network_Created.png]] | [[Image:Toolpack_v2.5_MTP3_Network_Created.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: Sub Service Field|Sub Service Field]] | ||
| + | * [[Parameter: Link Type|Link Type]] | ||
| + | * [[Parameter: DPC Length|SS7 DPC Length]] | ||
Revision as of 10:48, 4 August 2010
Now that you have created your system's MTP3 configuration, you must create a new MTP3 network. An MTP3 network is created to define its point codes, link sets and routes. This can be done from the MTP3 configuration information panel
To create an MTP3 network:
1- Click Create New MTP3 Network in the MTP3 configuration information panel
2- Configure the settings for the new network:
- Enter a name for the network
- Select a sub service field
- Select a link type
- Select the SS7 DPC length
- Click Create
3- Verify that the Mtp3Network was successfully created message appears
