Toolpack:Creating an SCCP Userpart A
| Line 31: | Line 31: | ||
[[Image:Toolpack_v2.5_SCCP_Userpart_Created.png]] | [[Image:Toolpack_v2.5_SCCP_Userpart_Created.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: Sub-System Number|Sub-System Number]] | ||
| + | * [[Parameter: First Concerned Point Code|First Concerned Point Code]] | ||
| + | * [[Parameter: Second Concerned Point Code|Second Concerned Point Code]] | ||
Revision as of 12:34, 5 August 2010
Now that you have configured an SCCP network, you must create a new SCCP user part for your system.
The user part is the container for the multiple SCCP interfaces. One user part is required for each protocol variant. Multiple SCCP user parts can be instantiated within a single SCCP protocol layer. This allows a user application to interface with multiple SS7 SCCP protocol variants at the same time. Only one SCCP user part is required for a specific variant as it can be assigned to multiple SCCP networks.
A user part can easily be seen as a protocol variant that a host application wants to use on the SS7 network.
To create an SCCP user part:
1- Click Create New SCCP User Part to access the SCCP configuration window
2- Configure the new SCCP user part
- Enter a name for the user part
- Enter a sub-system number
- Select the first concerned point code
- Select the second concerned point code
- Click Create
3- Verify that the "SCCP Userpart was successfully created" message appears
