Toolpack:Creating MTP3 Links (M2PA) A
From TBwiki
(Difference between revisions)
| Line 26: | Line 26: | ||
[[Image:Toolpack_v2.5_MTP3_Link_Created.png]] | [[Image:Toolpack_v2.5_MTP3_Link_Created.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: Type of Link to Bind|Type of Link to Bind]] | ||
| + | * [[Parameter: MTP2 Link|MTP2 Link]] | ||
| + | * [[Parameter: Priority Level|Priority Level]] | ||
| + | * [[Parameter: Message Priority|Message Priority]] | ||
| + | * [[Parameter: C Link|C Link]] | ||
| + | * [[Parameter: Link Test Slc|Link Test Slc]] | ||
| + | * [[Parameter: Link Test Characters|Link Test Characters]] | ||
Revision as of 15:34, 6 August 2010
Now that you have created an MTP3 linkset, you must create MTP3 links for it. This can be done from the MTP3 linkset configuration window. A linkset is used to logically combine multiple MTP3 links going to the same DPC into a single entity. One linkset could be comprised of the links between a point code identifying the Tmedia/Tdev SS7 node and a point code identifying the adjacent SS7 equipment.
To create an MTP3 link:
1- Click Create New Mtp3 Link in the MTP3 linkset configuration window
2- Configure the new MTP3 link:
- Enter a name for the link
- Under Type of link to bind, select M2PA.
- Select an MTP2 link
- Select a priority level (from 0 to 3)
- Select a message priority (from "none" to 3)
- Set the C Link value
- Enter a Link Test Slc (this value is unique in the link list)
- Enter Link Test Characters
- Click Create
3- Verify that the "Mtp3Link was successfully created" message appears
