Parameter: Loopback
From TBwiki
(Difference between revisions)
Allyntree (Talk | contribs)
(Created page with 'The Loopback parameter is used to set the loopback state of a line service. Values for this parameter are selected from a drop-down list. The Loopback parameter can take on the f…')
Newer edit →
(Created page with 'The Loopback parameter is used to set the loopback state of a line service. Values for this parameter are selected from a drop-down list. The Loopback parameter can take on the f…')
Newer edit →
Revision as of 10:50, 18 August 2010
The Loopback parameter is used to set the loopback state of a line service. Values for this parameter are selected from a drop-down list. The Loopback parameter can take on the following values:
- NONE (LS operational)
- LOS (LS out of service)
