Parameter: Loopback
From TBwiki
(Difference between revisions)
(Created page with 'The Loopback parameter is used to set the loopback state of a line service. Values for this parameter are selected from a drop-down list. The Loopback parameter can take on the f…') |
|||
| Line 3: | Line 3: | ||
* NONE (LS operational) | * NONE (LS operational) | ||
* LOS (LS out of service) | * LOS (LS out of service) | ||
| + | |||
| + | [[Category:Parameters]] | ||
Revision as of 10:56, 23 August 2010
The Loopback parameter is used to set the loopback state of a line service. Values for this parameter are selected from a drop-down list. The Loopback parameter can take on the following values:
- NONE (LS operational)
- LOS (LS out of service)
