Configuring IP Interfaces
From TBwiki
(Difference between revisions)
| Line 5: | Line 5: | ||
*Gateway | *Gateway | ||
| + | <br/> | ||
== To configure a VoIP0 or VoIP1 port == | == To configure a VoIP0 or VoIP1 port == | ||
| Line 22: | Line 23: | ||
* Enter a Netmask | * Enter a Netmask | ||
* Enter a gateway address | * Enter a gateway address | ||
| + | * Click '''Save''' | ||
''Note: the IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets'' | ''Note: the IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets'' | ||
| + | <br/> | ||
[[Image:Toolpack_v2.5_Editing_IP_Interface.png]] | [[Image:Toolpack_v2.5_Editing_IP_Interface.png]] | ||
| + | <br/> | ||
| − | '''4. The changes are displayed in the IP interfaces information panel | + | '''4. The changes are displayed in the IP interfaces information panel:''' |
| + | |||
| + | [[Image:Toolpack_v2.5_IP_Interface_Edited.png]] | ||
| + | <br/> | ||
| − | + | '''IMPORTANT!''' The system will display the following notice, describing steps to apply your new configuration: | |
| − | + | [[Image:Toolpack_v2.5_IP_Interface_Alert.png]] | |
Revision as of 16:16, 6 February 2011
The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:
- IP Address
- Netmask
- Gateway
To configure a VoIP0 or VoIP1 port
1. Select IP Interfaces from the navigation panel:
2. Click 'Edit' from the IP Interfaces Information panel:
3. Configure the port:
- Indicate whether or not to use DHCP on this port
- Enter an IP address
- Enter a Netmask
- Enter a gateway address
- Click Save
Note: the IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets
4. The changes are displayed in the IP interfaces information panel:
IMPORTANT! The system will display the following notice, describing steps to apply your new configuration:
