Toolpack:Creating an ISUP Network A
From TBwiki
(Difference between revisions)
Line 1: | Line 1: | ||
Now that you have created an initial ISUP stack, you must create a new ISUP network. | Now that you have created an initial ISUP stack, you must create a new ISUP network. | ||
− | The ISUP network tells the ISUP protocol layer about a collection of SS7 nodes that are accessible through MTP3. | + | The ISUP network tells the ISUP protocol layer about a collection of SS7 nodes that are accessible through MTP3 or M3UA. |
Based upon your system configuration, one or more ISUP networks are created. Repeat this section for as many networks as you require. | Based upon your system configuration, one or more ISUP networks are created. Repeat this section for as many networks as you require. | ||
Line 17: | Line 17: | ||
* Enter a '''name''' for the network | * Enter a '''name''' for the network | ||
− | * Select '''MTP3''' as the '''type of network to bind''' | + | * Select '''MTP3''' or '''M3UA''' as the '''type of network to bind''' |
− | * Select | + | * Select a '''MTP3 network''' or a '''M3UA network''' |
* Click '''Create''' | * Click '''Create''' | ||
Revision as of 10:31, 4 October 2011
Now that you have created an initial ISUP stack, you must create a new ISUP network.
The ISUP network tells the ISUP protocol layer about a collection of SS7 nodes that are accessible through MTP3 or M3UA. Based upon your system configuration, one or more ISUP networks are created. Repeat this section for as many networks as you require.
NOTE: An ISUP network can be used by multiple ISUP interfaces even if they are members of different ISUP userpart (e.g., to support multiple switch variants for a single SS7 network).
To create an ISUP network:
1- Click "Create New ISUP Network" in the ISUP stack configuration window
2- Configure the new ISUP network:
- Enter a name for the network
- Select MTP3 or M3UA as the type of network to bind
- Select a MTP3 network or a M3UA network
- Click Create
3. Verify that the "IsupNetwork was successfully created" message appears
List of Parameters
- Name
- Type of Network to Bind
- Depending on the type chosen: