Symmetric NAT Traversal

Tmedia supports NAT (Network Address Translation) Traversal.

TelcoBridges and Passive NAT Traversal

Tmedia supports passive NAT Traversal that addresses the need of peer VoIP endpoint having a private network address. This endpoint device is situated behind a NAT device, e.g. Firewall, while the Tmedia VoIP port has a public IP address. For the passive mode, TMG detects the received RTP packet's source IP address and port. In response, Tmedia uses this source IP address and port as the packet destination for RTP.

This is also called Remote NAT traversal or far-end NAT traversal.

TelcoBridges and Active NAT Traversal

Active NAT traversal means the TMG endpoint is behind a NAT. The Tmedia unit can advertise a public IP so that the remote device will know where to send the RTP traffic. It can also send the 'a=direction:active' in SIP SDP attribute so that the remote device puts itself in passive mode.

This is also called Local NAT traversal or near-end NAT traversal.

Typical Use Case

Important Reminders

• All devices in the path must support symmetric RTP/RTCP: RFC 4961

Configuration

• Configure NAT Traversal for version 3.0
• Configure NAT Traversal for version 2.10
• Configure NAT Traversal for version 2.9
• Configure NAT Traversal for version 2.8
• Toolpack v2.7: SIP Advance Features
• Toolpack v2.6: SIP Advance Features

External Sources

• RFC 4961 Symmetric RTP / RTP Control Protocol (RTCP)