Configuring VoIP Interfaces

From TBwiki

Revision as of 12:59, 24 October 2017 by Allyntree (Talk | contribs)

The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:

To configure a VoIP0 or VoIP1 port

1. Select IP Interfaces from the navigation panel:

2. Click the IP Interfaces tab.

3. Configure the IP port:

Enter a name for the interface
Select a service to use for the IP inteface
Select a Virtual port from which IP packets will exit.
Indicate whether or not to use DHCP to automatically get an IP address for this port. (selecting this option removes the need to enter and IP address, Netmask, and Gateway)
Enter an IP address
Enter a Netmask
Enter a gateway address
Click Save

Note: IP addresses using different virtual ports must be on different subnets.

4. The changes are displayed in the IP interfaces information panel:

5. Activate the configuration

Systems -> Edit -> Activate

6. It is necessary to reboot the adapters if you are using the vlan from 3441 to 3450 only.

Status -> Adapters -> Click on the adapter Serial Number -> Reboot adapter

It will take about 1.5 minutes to restart the unit.

Note: in a 1+1 system, both units must be restarted.