Configuring Toolpack:SIP to ISDN Gateway

Introduction

This guide is intended to help Toolpack user to configure a SIP to ISDN Gateway.

This guide assumes the following:

• Toolpack version is v2.4.
  
• Toolpack is already installed and running on the host.
  
• The system contain 1 SIP provider and 1 ISDN provider.
  
• Routing: All incoming SIP calls are bridged to ISDN and all incoming ISDN calls are bridged to SIP.
  
• CDR will be saved using Toolpack text CDR
  

Before starting

Here is a list of mandatory information that the user must know before configuring Toolpack:

ISDN

• Line Interface(s) type and parameters (T1, E1, DS3, STM-1).
  
• Line Service(s) type and parameters.
  
• ISDN stack(s) variant(s).
  
• Network side: User or network.

SIP

• SIP IP address(es) (IP address of your system where the SIP signaling will be incoming).
  
• SIP provider(s)/consumers IP address(es) (remote IP address).
  
• SIP port (default:5060).
  
• SIP port type: UDP or TCP (default: UDP).