Toolpack: Navigating the Web Portal

Applies to version(s): v2.5, v2.6.

For the configuration of your SIGTRAN M2PA system, you will first need to create a new M2PA configuration. In this system, the SS7 MTP2 layer is replaced by the SIGTRAN M2PA layer which extends MTP2 signaling functionality into the IP network.

Note: M2PA replaces the MTP2 layer entirely; however, it still requires the MTP3 layer.

To create an M2PA configuration:

1- Click M2PA in the navigation panel

2- Configure the new M2PA service

• Verify that the Enabled box is checked
• Enter a name for the M2PA configuration
• Click Create

3- Verify that the "M2pa Cfg was successfully created" message appears

List of Parameters

• Enabled
• Name