Configuring VoIP Interfaces

Applies to version(s): v2.8.

The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:

• IP Address
• Netmask
• Gateway

To configure a VoIP0 or VoIP1 port

1. Select IP Interfaces from the navigation panel:

2. Select the IP Interfaces tab and click Create New IP Interface from the IP Interfaces Information panel:

3. Configure the IP port:

• Enter a name for the interface
• Select a service to use for the IP inteface
• Indicate whether or not to use DHCP (dynamic IP) on this port
• Enter an IP address
• Enter a Netmask
• Enter a gateway address
• Click Save

Note: The IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets.

4. The changes are displayed in the IP interfaces information panel:

5. Activate the configuration

Systems -> Edit -> Activate

6. Reboot the adapter (will drop active calls)

Status -> Adapters -> Click on the adapter Serial Number -> Reboot adapter

It will take about 1.5 minutes to restart the unit.

Note: in a 1+1 system, both units must be restarted.

List of Parameters

• Use DHCP
• IP Address
• Netmask
• Gateway