Creating an N+1 Group

From TBwiki
Revision as of 10:24, 24 November 2014 by Allyntree (Talk | contribs)
Jump to: navigation, search

Applies to version v2.8

Once the N+1 patch panel is created, you must configure an N+1 group and assign each hardware unit to their correct position on the N+1 pacth panel.

To create an N+1 Patch Panel:

1- Click N+1 in the navigation panel


N Plus One 0 A.png


2- Click Create New N+1 Group


N Plus One 1 A.png


3- Set the correct serial numbers for units that are assigned as Primary and Secondary N+1 Patch panels, as well as the N+1 Backup unit.

  • Configure the following:
    • Primary N+1 Patch Panel: N+1 patch panel for the main fiber
    • Secondary N+1 Patch Panel: N+1 patch panel for the APS
    • N+1 Backup Unit: Standby unit
    • Auto switch-back: Select this option to automatically switch TDM and VoIP media back to the original unit when it becomes available. If this option is not selected, then the backkup unit will remain active until it is manually rebooted.
    • Port 0 to 14: Units must be listed as they are physically connected to the N+1 patch panel.
  • Click Create

N Plus One 2 A.png


4- Verify that the newly added N+1 patch panel appears in the N+1 Groups list.


N Plus One 3 A.png

Retrieved from "https://docs.telcobridges.com/mediawiki/index.php?title=Toolpack:Creating_a_N%2B1_Group_B&oldid=17246"
Personal tools