Creating an M3UA SAP (IPSP)

Applies to version(s): v2.9

Once an M3UA configuration is created, you must then create a new M3UA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.

To create an M3UA SAP:

1- Click M3UA in the navigation panel:

2- Click Create New M3ua Sap in the M3UA configuration panel

3- Configure the new SAP:

• Enter a name for the SAP
• Select an Unit to use
• Select an SCTP source port
• Click Create

4- Verify that the "M3ua Sap was successfully created" message appears

5- Associate an IP interface with the new SAP:

• Select an available IP interface
• Click the"<<" button to associate the interface with the SAP

Path

Parameters (text)

Parameters (json)

List of Parameters

• Name
• SCTP Adapter
• SCTP Source Port

M3UA SAP Timers

• SCTP Primitive Timer
• SCTP Association Timer

• Maximum data size
• Maximum ACK delay
• Maximum datagram before ACK
• Initial Retransmission Timeout (RTO)
• Minimum Retransmission Timeout (RTO)
• Maximum Retransmission Timeout (RTO)
• Freeze timer
• Bundle timer
• Cookie life time
• Delay between heartbeat
• Maximum datagram burst
• Maximum heartbeat at each RTO
• Shutdown Guard Timer
• Handle INIT datagram
• Abort negociation if nb. streams mismatch
• Flow-control up threshold
• Flow-control down threshold