Creating an M3UA Route

Applies to version(s): v2.9

Once you have configured M3UA user parts, PSPs, and peer servers, you must create M3UA routes for your system.

You require one route per point code. This means one route per destination point code (DPC) (SSP and STP) and one route for each originating point code (OPC).

To create an M3UA route on an IPSP:

1- Click M3UA in the navigation panel:

2- Select an M3ua Network:

3- Click Create New M3ua Route in the M3UA network configuration window

2- Configure the new M3UA route:

For OPC: This route is used for local point code and to reach the ASP.

• Enter a name for the route
• Select a route type:Psrv
• Select an M3UA peer server: Select the previously configured M3US Peer Server with the right RC
• Select an M3UA user part:NONE
• Select a point code: Select the OPC from the MTP3 linkset
• Select a point code mask (Recommended value: Exact match)
• Select a sub-service field type:ISUP or SCCP
• Click Create

For DPC: This route is used to reach the DPC used in MTP3 configuration.

• Enter a name for the route
• Select a route type:Mtp3
• Select an M3UA user part: Select the previously configured M3UA User Part
• Select a point code: Select the DPC from the MTP3 linkset
• Select a point code mask (Recommended value: Exact match)
• Select a sub-service field type:ISUP or SCCP
• Click Create

3- Verify that the "M3ua Route was successfully created" message appears

Path

Parameters (text)

Parameters (json)

List of Parameters

• Name
• Route Type
• M3UA Peer Server (only if Psrv was chosen as the route type)
• M3UA Userpart
• Point Code
• Point Code Mask
• Sub-Service Field Type