Creating M2UA Links
From TBwiki
Applies to version(s): v2.9, v2.10
AFter you create an M2UA cluster, you must create M2UA links for your system.
An M2UA link is always bound to an MTP2 link, and can be seen a way of extending MTP2 functionality.
To create an M2UA link:
1- Click M2UA in the navigation panel
2- Select an M2UA SAP
3- Select an M2UA Cluster
4- Click Create New M2ua Link in the M2UA cluster configuration window:
5- Configure the new M2UA link:
- Enter a name for the link
- IMPORTANT!
- For a system on a signaling gateway: Select an MTP2 link
- For a system on a media gateway controller: Select NONE
- Select a protocol type (same as MTP2)
- Select an interface ID type
- Enter an appropriate interface ID (must be unique to each link)
- Click Create
6- Verify that the "M2ua Link was successfully created" message appears
Path
/configurations/@[configuration_name]/hardware_units/@[hardware_name]/m2ua_stacks/@[m2ua_stack]/m2ua_saps/@[m2ua_sap]/m2ua_clusters/@[m2ua_cluster]/m2ua_links/@[m2ua_link]
Parameters (text)
/configurations/@[configuration_name]/hardware_units/@[hardware_name]/m2ua_stacks/@[m2ua_stack]/m2ua_saps/@[m2ua_sap]/m2ua_clusters/@[m2ua_cluster]/m2ua_links/@[m2ua_link] intf_id = "1" intf_id_type = "Integer" mtp2_link = "NONE" name = "@[m2ua_link]" protocol_type = "ITU" /configurations/@[configuration_name]/hardware_units/@[hardware_name]/m2ua_stacks/@[m2ua_stack]/m2ua_saps/@[m2ua_sap]/m2ua_clusters/@[m2ua_cluster]/m2ua_links/@[m2ua_link]/state target_link_state = "Connected"
Parameters (json)
{
"intf_id" : "1",
"intf_id_type" : "Integer",
"mtp2_link" : "NONE",
"name" : "@[m2ua_link]",
"protocol_type" : "ITU",
"state" : {
"target_link_state" : "Connected"
}
}
