Ethernet Bonding
From TBwiki
Ethernet Bonding enables SBC and Tmedia units to use the two Ethernet ports as a bonding pair. When the active port becomes unusable (cable disconnected, limited connectivity), the other port is used to transport Ethernet traffic.
Note: Ethernet bonding can be configured on an SBC and a 7800-ctrl, but only when running these units are configured in a Bare Metal mode.
Configuration
To learn how to configure ethernet bonding, refer to:
- To learn how to configure ethernet bonding for an FreeSBC or ProSBC, refer to FreeSBC/ProSBC Initial Configuration
- To learn how to configure ethernet bonding for a TMG7800, refer to TMG7800 Initial Configuration
Display Status
To learn about how to view the status, refer to:
