Configuring IP Interfaces

The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:

• IP Address
• Netmask
• Gateway

To configure a VoIP0 or VoIP1 port

1. Select IP Interfaces from the navigation panel:

2. Click 'Edit' from the IP Interfaces Information panel:

3. Configure the port:

• Indicate whether or not to use DHCP on this port
• Enter an IP address
• Enter a Netmask
• Enter a gateway address
• Click Save

Note: the IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets

4. The changes are displayed in the IP interfaces information panel:

IMPORTANT! The system will display the following notice, describing steps to apply your new configuration:

List of Parameters

• Use DHCP
• IP Address
• Net Mask
• Gateway