Modifying Profile for SPIROU
From TBwiki
Revision as of 13:07, 14 December 2012 by Manon Bélanger (Talk | contribs)
Applies to version(s): v2.6, v2.7.
This section assumes:
- SS7 ISUP is already configured
Note that if you want to eventually validate SPIROU configuration, you will need to repeat these steps for all the profiles in your current configuration..
1- Select Profiles from the navigation panel
2- Click on the Edit button for the profile you want to configure
3- Expand the SIP section and check the following parameters
- Forward SS7 suspend/resume must be checked
- Forward SS7 CPG hold/retrieval must be checked
- Forward SIP hold type must be set to SS7 Suspend/Resume or SS7 Remote Hold/Retrieval
- Max Forwards header handling must be set to Decrement and forward
4- Expand the SS7 section and check the following parameters
- Forward call suspend/resume must be checked
- Forward call CPG hold/retrieval must be checked
- Hop Counter IE handling must be set to Decrement and forward
5- Expand the SS7 or ISDN section and check the following parameter
- Information transfer capability must be set to Relay
6- Click the Save button
7- Verify that the "Profile was successfully updated" message is displayed
