Modifying ISUP Userpart for SPIROU

Applies to version(s): v2.6, v2.7.

This section assumes:

• SS7 ISUP is already configured

1- Select SS7-->ISUP from the navigation panel

2- Click on the Edit button for the ISUP stack you want to configure

3- In the Editing Userparts section, click on the ISUP userpart you want to configure

4- Select SPIROU in the Protocol Variant drop-down menu

5- A new checkbox Strict SPIROU validation appears once SPIROU Protocol Variant is selected.

• Check this new checkbox to make sure your configuraton is compliant with SPIROU.

6- Click Timers to expand the Timers section

7- Set T6 Timer between 60000 and 120000 ms (between 60 and 120 seconds)

8- Click the Save button

9- Verify that the "IsupUserpart was successfully updated" message is displayed

List of Parameters

• Protocol Variant
• Strict SPIROU validation
• Timers