Creating an M2PA SAP

Applies to version(s): v2.7.

Now that you have created an M2PA configuration, you must create a new M2PA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.

To create a new M2PA SAP:

1- Select M2PA from the navigation panel

2- Click Create new M2pa Sap

3- Configure the new M2PA SAP:

• Enter a name for the SAP
• Enter an SCTP source port for the SAP
• Click Create

4- Verify that the "M2pa Sap was successfully created" message appears

5- Associate IP interfaces

• Select an IP interface from the list in the information panel
• Click the "<<" button to add the selected IP interface. This is the outgoing route from the hardware adapter.

List of Parameters

• Name
• SCTP Source Port