Creating SS7 Point Codes

Applies to version(s): v2.8.

Once you have configured your MTP3 network, you must then create point codes for your system. Point codes are used to define the Tmedia or Tdev system network, the adjacent network and the target network so that calls are properly routed from one network to the next.

To create SS7 originating (OPC) and destination (DPC) point codes:

1- Click Point Codes in the navigation panel

2- Click Create New Point Code

3- Configure the new point code:

• Enter a name for the point code
• Select a point code type (select type-specific parameters)
• Select a point code length (14, 16, 24 bits)
• Enter a point code
• Click Create

In this example, an originating point code (OPC) is created.

4. Verify that the "Mtp3PointCode was successfully created" message appears, and the new point code appears in the Point Codes list

List of parameters

• Name
• Type
• DPC Length
• Point Code