Creating the M2PA Configuration

Applies to version(s): v2.8.

Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensures reliable, in-sequence transport of messages.

To edit your system's SCTP configuration:

1- Select SCTP from the navigation panel

2- Configure the SCTP service

• Make sure the box labelled Enabled is checked
• Enter a name for the SCTP service
• Select an appropriate service type:
  • RAW_IP
  • UDP
• Click Create

3- Verify that the "Sctp Cfg was successfully created" message appears

List of Parameter

• Name
• Service Type