Modifying ISUP Stack for SPIROU

Applies to version(s): v2.8.

This article assumes that SS7 ISUP is configured.

Note that if you want to eventually validate SPIROU configuration, you will need to repeat these steps for all the ISUP stacks in your current configuration..

1- Select ISUP from the navigation panel

2- Select the ISUP stack you wishto configure.

3- Expand the Advanced Parameters section and set the following parameters:

• No confusion must be selected
• Click Save

4- Verify that the "IsupStack was successfully updated" message is displayed

List of Parameters

• Isup Stack Options