Toolpack:Modifying TMG Control Network A

Caution

• Resetting the role after this procedure will reset the network settings to their default values

Example

This example shows the procedure for control 0 over vlan 710 only.

1. user SSH connect to the TMG
2. Telnet on telecom section of the Tmedia
3. Use 'set_boot'
   1. modify eth0 IP addresses
   2. Modify eth0 netmask
   3. Set the eth0 gateway to the same IP as eth0 IP address
4. Validate your values with the 'print_boot' command
5. reboot
6. Back on the host section, Change the file /etc/sysconfig/network-scripts/ifcfg-vlan710
   1. Modify IPADDR
   2. Modify NETMASK
   3. save file
7. stop toolpack => 'tbtoolpack stop'
8. restart network service => 'service network restart'
9. start toolpack => 'tbtoolpack start'