Allocating a SIP Network Access Point (NAP)

Applies to version(s): v2.10

You must allocate a SIP NAP for your system. This is very similar to the ISDN NAP. To create a new NAP:

1- Click NAPs in the navigation panel

2- Click Create New NAP

3- Create the new NAP:

• Enter a name for the NAP
• Click Create

4- Verify that the NAP was successfully created message appears

5- Associate a SIP service access point with the new NAP:

• Select a SIP SAP from the Available list
• Click "<<" to associate the SIP SAP with the NAP

6- Configure settings for the following parameter groups as required:

• Filtering Parameters
• Registration Parameters
• Authentication Parameters
• Network Address Translation
• SIP-I Parameters
• Advanced Parameters

• Click Save

List of Parameters

• Name
• Default Profile

• Proxy Address
• Proxy Port Type
• Proxy Port
• Poll Remote Proxy

• Filtering Params:
  • Filter by proxy address
  • Filter by local port

• Registration Params:
  • Register to proxy
  • Address to register

• Authentication Params:
  • Ignore Realm
  • Reuse challenge
  • Realm
  • User
  • Password

• Network Address Translation:
  • Remote Method
  • Local Method

• SIP-I Parameters:
  • Enable
  • ISUP Protocal Variant
  • Content-Type
  • Call Progress Method
  • Append F to outgoing calls

• Advanced Parameters:
  • Map any response to available status
  • 183 triggers call process
  • Privacy Type

• Maximum calls per second
• Maximum call burst
• Maximum simultaneous incoming calls
• Maximum simultaneous outgoing calls
• Maximum simultaneous total calls
• Processing Delay Low Threshold
• Processing Delay High Threshold

• Number of calls per period
• Period Duration