FreeSBC:SIP Trunking:Example A

Introduction

The SIP Trunking Example Configuration provides you with a step by step SIP trunking Configuration of FreeSbc systems, using the Web Portal configuration tool. Complete general installation configuration steps, before you begin configuring your specific scenario.

Prerequisites

FreeSbc devices must be installed as described in their respective installation guides.

IP Network Configuration

Virtual Port Configuration

1. Select IP Interfaces from the navigation panel

2. Click the Virtual Ports tab.

• Click Create New Virtual Port

3. Configure the virtual port.

• Enter a name for the virtual port
• Select the host(s) to which the virtual port is assigned
• Select a physical port to which the virtual port is assigned

• Click Create

4. Create a VLAN that uses this virtual port

• Click Create new Host VLAN

5. Configure the new VLAN

• Enter a name for the VLAN
• If the port is to be used untagged, make sure Untagged is checked.
• If the port is to be used with a 802.1Q tag, uncheck Untagged and enter a VLAN ID.
• Click Create

OR