Creating SS7 Point Codes
Applies to version(s): v3.0
Point codes are used to define the adjacent and target networks so that calls are properly routed from one network to the next.
To create a destination point code (DPC):
1- Click Point Codes in the navigation panel
2- Click Create New Point Code
3- Configure the new point code:
- Enter a name for the point code
- Select a point code type (select type-specific parameters)
- Select a point code length (14, 16, 24 bits)
- Enter a point code. Either as bits, decimal, or hexadecimal.
- Click Create
In this example, an originating point code (OPC) is created.
4. Verify that the "PointCode was successfully created" message appears, and the new point code appears in the Point Codes list
To create an originating point code (OPC):
1- Click Point Codes in the navigation panel
2- Click Create New Point Code
3- Configure the new point code:
- Enter a name for the point code
- Select a point code type (select type-specific parameters)
- Select a point code length (14, 16, 24 bits)
- Enter a point code. Either as bits, decimal, or hexadecimal.
- Click Create
In this example, an originating point code (OPC) is created.
4. Verify that the "PointCode was successfully created" message appears, and the new point code appears in the Point Codes list
