Creating SS7 Point Codes

Applies to version(s): v3.0

Point codes are used to define the adjacent and target networks so that calls are properly routed from one network to the next.

To create a destination point code (DPC):

1- Click Point Codes in the navigation panel

2- Click Create New Point Code

3- Configure the new point code:

• Enter a name for the point code
• Select a point code type (select type-specific parameters)
• Select a point code length (14, 16, 24 bits)
• Enter a point code. Either as bits, decimal, or hexadecimal.
• Click Create

Create an originating point code (OPC):

1- Configure the new point code:

• Enter a name for the point code
• Select a point code type (select type-specific parameters)
• Select a point code length (14, 16, 24 bits)
• Enter a point code. Either as bits, decimal, or hexadecimal.
• Click Create

4. Verify that the "MTP3 PointCode was successfully created" message appears, and the new point code appears in the Point Codes list

List of parameters

• Name
• Type
• Length
• Point Code