ProSBC/FreeSBC Initial Configuration

Applies to version(s): v3.0, v3.1

The initial configuration of the SBC is done by accessing a configuration wizard in a web browser (Chrome, Firefox or other). Before you begin, you must have the following information on hand:

• Product key: In the following VTB-XXX-XXXX format. If you do not have this key, please go to our ProSBC Download site .
• Hostname of the unit. It is important to set the host name correctly and to not modify it later, otherwise you will need a new license.
• Will the system be used as a standalone unit or in a Primary/Secondary configuration?
• Does the system require external transcoding? For example, G.711 to G.729a transcoding.
• The role of each of the network interfaces

Once you have this information, proceed as indicated below:

Initial configuration of the SBC

1- Open a web browser to the IP of your server, on port 12358. For example, if your server address is 192.168.178.30, the URL would be:
http://192.168.178.30:12358

2- An SBC Configuration Wizard is displayed.

• Click Continue
  

3- Accept the EULA agreement


4- Enter your activation key and hostname
** No need to enter the host name for AWS.


5- Enter your SSH and WEB root password
** No need to enter the SSH password for AWS.


6- Select the configuration of your SBC. Either standalone, or in a Primary/Secondary configuration
** Not applicable for AWS.


7- If the system requires external transcoding, select it here. As an example, if the system needs G.711 to G.729a transcoding, then select yes.
** Not applicable for AWS.


8- In this window, you define the role of the network adapters in the system. The following is a short description of each type:

• mgmt: Used for management of the system (suggested name: mgmt0)
• ctrl0: Used for communication with the external transcoding devices (suggested name: ctrl0)
• ctrl1: Same as ctrl0. Adds redundancy (suggested name: ctrl1)
• LAN/WAN: SIP/RTP access to private network (suggested name: LAN0) or public network (suggested name: WAN0).

You must configure all IP interfaces. If you are not sure, configure them as management interfaces.

new images 9- To add an Ethernet Bonding, click Add Bonding.

Select the "+" sign to get further information about an interface

 
 

If 1+1 (control networks ctrl0/ctrl1) or multiple vlan interfaces are needed, make sure all of them are assigned to the appropriate MAC address taken from the Platform (VMware Instance settings or other)

10- Once completed, you will be asked get the license seed of this unit to allow for license installation. Please go here for instructions: Retrieving a License for SBC Units
To get help, please contact TelcoBridges TB Support.