Toolpack v2.4:Create an MTP3 Configuration

MTP3 provides message routing between signaling points in an SS7 network.

To create an MTP3 configuration:

1. Select "MTP3" from the navigation panel:

2. Configure the new MTP3 service:

• Enter a name for the MTP3 configuration
• Set Enabled status:
• Select SP as the signalling point type
• Set SSf validation:
• Select a restart procedure:
  • None
  • ITU88 (protocol variant)
  • ITU92 (protocol variant)
  • ANSI
• Set a value for "Transfer Restricted Required":
• Click "Save" to finalize the configuration

3. Verify that the "Mtp3Cfg was successfully updated" message appears: